Oil cooler with advanced science and technology, the use of professional design, novel structure, reliable performance is high.
Oil cooler in use are often appear leakage problem, how to prevent oil cooler leak? The following detailed introduction for you:
In view of the oil cooler leakage fault, has carried on the analysis and processing as follows:
1, lower the temperature of the inlet, the demolition of the oil cooler inlet pipeline, add for the two weld water jacket, using recycled water for cooling, can make the inlet temperature of cooling oil reduces the eight degrees, greatly reduce the stress,
2, eliminate the stress of the part (in the cold oil equipment cylinder increase expansion joint)
3, in order to eliminate the bilge holding force, condensing column between tube and tube sheet of the cooler USES of expansion and welding can choose directly.
4, for Cl - corrosion problems, can take to reduce circulating water Cl - concentration, reduced corrosion of Cl -.
5, cooler for high temperature gas scour the tube entrance, you can directly to avoid impingement plates with gas at the entrance of wash column pipe, avoid the temperature too high, put an end to the phenomenon of rapid cooling water evaporation.
6, the oil cooler tube plate by the composite board into a stainless steel plate to avoid because of shell and tube cooler leakage corrosion of tube sheet.
Oil cooler in use, leakage phenomenon is inevitable, we should pay attention when using, so as not to cause unnecessary damage.
The above:
The performance of the air cooler 
Pressure switch
Chinese
Deutsch
Espanol
Francais
Italiano
Portugues
Japanese
Korean
Arabic
Russian