Gear pump installation method

The gear pump is used for lubricating oil in the lubrication system of various mechanical equipments.

How the gear pump works

1. The pump is not suitable for transporting dirty oil, so the oil filter should be set in the inlet pipe

2. The pump has no safety valve, it is recommended to set up the safety valve in the drainage pipeline to ensure the safe operation of the system.

3. The steering requirement of pump: from the pump end to the motor, the rotation direction is counterclockwise.

4. The unit shall be installed on the horizontal cement foundation and the ground bolts shall be fixed.

5. The installation height of the pump shall not exceed the allowable height

6. The right coupling should be coaxial. After the installation is completed, the rotating coupler will be able to enter the operation without negative pressure. This pump is a positive displacement pump, the main around, passive gear and pump body, pump cover of the oil, the oil two closed space, when the gears, the oil cavity, the volume of meshing teeth off constantly, and changes from small to big. Form a vacuum, the liquid suction, toothed valley to the oil cavity, the volume of the oil cavity, due to the constant into the mesh of the meshing teeth and large to small, oil is displaced by compression, so as to achieve the aim of oil. This series of pumps is mainly composed of: left, right pump cover, pump body, main, passive gear shaft, shaft sleeve, oil seal, etc.

2CY gear pump use and installation

1. The installation height of the pump shall not exceed the allowable height.

2. The gear pump is not suitable for transporting dirty oil, so the oil filter should be set in the inlet pipe.

3. The gear pump has no safety valve, and it is recommended to set up the safety valve in the discharge line to ensure the safe operation of the system.

4. The right coupling should be coaxial. After the installation is completed, the rotating coupler will be able to enter the operation without negative pressure.

5. The unit shall be installed on the horizontal cement foundation and the ground bolts shall be fixed.

6. The steering requirement: from the pump end to the motor, the rotation direction is counterclockwise.

The above:The development prospect of high pressure gear pump in China